MINI Paceman lug nut torque
The 2013 MINI Paceman takes 103.3 lb-ft (140 N·m) on its wheel nuts, according to its owner’s manual. Tighten them in a star pattern with a torque wrench.
Sources checked
Wheel nut torque
103.3lb-ft140N·m
- As printed
- “Tightening torque: 103.3 lb ft or 140 Nm.”
MINI Paceman lug nut torque by model year
| Model year | Torque | Manual page |
|---|---|---|
| 2013 | 103.3 lb-ft (140 N·m) | PDF page 234 |
Read on MINI’s own site on October 29, 2026. Years not listed haven’t been checked yet, or their manual prints no value; check your own manual.
How to tighten them
- Clean any dirt or rust off the studs, the nuts and the wheel’s mounting face. Don’t oil them unless the manual says to.
- Thread every nut on by hand until it seats against the wheel.
- Lower the vehicle so the tire takes its weight, and set a torque wrench to 103.3 lb-ft (140 N·m).
- Tighten the nuts in a star pattern, going around two or three times, until the wrench clicks on every nut.
- Check the torque again after a short drive if your manual says to.
More detail, including how many passes to make: how to torque lug nuts. Setting and using the wrench: how to use a click torque wrench. Nuts or bolts, car by car: lug nuts vs wheel bolts.
Other MINI models
- MINI Clubman101 or 103.3 lb-ft, by model year, 2008–2014, 2016, 2018–2024
- MINI Convertible88.5, 101 or 103.3 lb-ft, by model year, 2005–2025
- MINI Countryman101 or 103.3 lb-ft, by model year, 2011–2013, 2018–2025
- MINI Coupe103.3 lb-ft (140 N·m), 2012–2015
- MINI Hardtop 2 Door72, 88.5, 101 or 103.3 lb-ft, by model year, 2002–2025
- MINI Hardtop 4 Door101 lb-ft (140 N·m), 2015–2025
- MINI John Cooper Works GP101 lb-ft (140 N·m), 2021
- MINI Roadster103.3 lb-ft (140 N·m), 2012–2015
Questions
What is the lug nut torque on a MINI Paceman?
103.3 lb-ft (140 N·m), as printed in MINI’s owner’s manual (2013).
Can I use an impact wrench?
Not to finish. An impact wrench can’t set a torque and easily overshoots it, which stretches studs. Run the nuts down by hand or lightly, then finish with a torque wrench in a star pattern.
Should I oil the studs?
Not unless the manual says so. Torque values assume clean, dry threads; oil lets the same torque stretch the stud further. Some manuals, Kia’s and Mazda’s among them, say to keep oil and grease off wheel nuts and bolts altogether.