Jaguar I-PACE lug nut torque
Jaguar I-PACE owner’s manuals give 98 lb-ft (133 N·m) for 2020–2024 and 85–99 lb-ft (115–135 N·m) for 2019. Check which applies to yours. Tighten them in a star pattern with a torque wrench.
Sources checked
Wheel nut torque, 2020–2024
98lb-ft133N·m
- As printed
- “Tighten the nuts, in the sequence shown in the illustration, to the correct torque of 98 lb.ft (133 Nm).”
Jaguar I-PACE lug nut torque by model year
| Model year | Torque | Manual page |
|---|---|---|
| 2024 | 98 lb-ft (133 N·m) | Wheel changing |
| 2023 | 98 lb-ft (133 N·m) | Wheel changing |
| 2022 | 98 lb-ft (133 N·m) | Wheel changing |
| 2021 | 98 lb-ft (133 N·m) | Wheel changing |
| 2020 | 98 lb-ft (133 N·m) | Wheel changing |
| 2019 | 85–99 lb-ft (115–135 N·m) | Wheel changing |
Read on Jaguar’s own site on October 29, 2026. Years not listed haven’t been checked yet, or their manual prints no value; check your own manual.
How to tighten them
- Clean any dirt or rust off the studs, the nuts and the wheel’s mounting face. Don’t oil them unless the manual says to.
- Thread every nut on by hand until it seats against the wheel.
- Lower the vehicle so the tire takes its weight, and set a torque wrench to the value for your model year in the table above.
- Tighten the nuts in a star pattern, going around two or three times, until the wrench clicks on every nut.
- Check the torque again after a short drive if your manual says to.
What the Jaguar manual adds
- With all of the wheels on the ground and the jack removed, fully tighten the lug nuts.
- With all of the wheels on the ground and the jack removed, fully tighten the wheel nuts.
More detail, including how many passes to make: how to torque lug nuts. Setting and using the wrench: how to use a click torque wrench. Nuts or bolts, car by car: lug nuts vs wheel bolts.
Other Jaguar models
Questions
What is the lug nut torque on a Jaguar I-PACE?
98 lb-ft (133 N·m) for 2020–2024; 85–99 lb-ft (115–135 N·m) for 2019, as printed in Jaguar’s owner’s manuals (2019–2024).
Can I use an impact wrench?
Not to finish. An impact wrench can’t set a torque and easily overshoots it, which stretches studs. Run the nuts down by hand or lightly, then finish with a torque wrench in a star pattern.
Should I oil the studs?
Not unless the manual says so. Torque values assume clean, dry threads; oil lets the same torque stretch the stud further. Some manuals, Kia’s and Mazda’s among them, say to keep oil and grease off wheel nuts and bolts altogether.