Ford F-150 Heritage lug nut torque

The 2004 Ford F-150 Heritage owner’s manual gives 150 lb-ft (200 N·m) for Five-lug wheels and 100 lb-ft (135 N·m) for Heavy Payload Package, seven-lug wheels. Check which applies to yours. Tighten them in a star pattern with a torque wrench.

Sources checked

Wheel nut torque, Five-lug wheels

150lb-ft200N·m

0501001502000100200300ft-lbN·m
As printed
“Wheel lug nut torque, F-150 (five lug nut wheel), M14 x 2.0: 150 lb.ft., 200 N·m”
Stud thread
M14 x 2.0
Source
2004 F-150 Heritage Owner's Manual (Ford): Wheel Lug Nut Torque Specifications, PDF page 159

Ford F-150 Heritage lug nut torque by model year

Model yearVersionTorqueManual page
2004Five-lug wheels150 lb-ft (200 N·m)Wheel Lug Nut Torque Specifications, PDF page 159
2004Heavy Payload Package, seven-lug wheels100 lb-ft (135 N·m)Wheel Lug Nut Torque Specifications, PDF page 159

Read on Ford’s own site on October 24, 2026. Years not listed haven’t been checked yet, or their manual prints no value; check your own manual.

How to tighten them

  1. Clean any dirt or rust off the studs, the nuts and the wheel’s mounting face. Don’t oil them unless the manual says to.
  2. Thread every nut on by hand until it seats against the wheel.
  3. Lower the vehicle so the tire takes its weight, and set a torque wrench to the value for your version in the table above.
  4. Tighten the nuts in a star pattern, going around two or three times, until the wrench clicks on every nut.
  5. Check the torque again after a short drive if your manual says to.

What the Ford manual adds

  • Torque specifications are for nut and bolt threads free of dirt and rust.
  • Use only Ford recommended replacement fasteners.

More detail, including how many passes to make: how to torque lug nuts. Setting and using the wrench: how to use a click torque wrench. Nuts or bolts, car by car: lug nuts vs wheel bolts.

Other Ford models

Questions

What is the lug nut torque on a Ford F-150 Heritage?

150 lb-ft (200 N·m) for Five-lug wheels; 100 lb-ft (135 N·m) for Heavy Payload Package, seven-lug wheels, as printed in Ford’s owner’s manuals (2004).

Can I use an impact wrench?

Not to finish. An impact wrench can’t set a torque and easily overshoots it, which stretches studs. Run the nuts down by hand or lightly, then finish with a torque wrench in a star pattern.

Should I oil the studs?

Not unless the manual says so. Torque values assume clean, dry threads; oil lets the same torque stretch the stud further. Some manuals, Kia’s and Mazda’s among them, say to keep oil and grease off wheel nuts and bolts altogether.