Ford Explorer Sport Trac lug nut torque

The Ford Explorer Sport Trac takes 100 lb-ft (135 N·m) on its wheel nuts; the 2004–2005, 2007–2010 manuals all say the same. Tighten them in a star pattern with a torque wrench.

Sources checked

Wheel nut torque

100lb-ft135N·m

04080120050100150ft-lbN·m
As printed
“Wheel lug nut torque, 1/2 x 20: 100 lb.ft., 135 N·m”
Stud thread
1/2 x 20
Socket
19 mm
Source
2010 Explorer Sport Trac Owner's Manual (Ford): Wheel Lug Nut Torque Specifications, PDF page 269

Ford Explorer Sport Trac lug nut torque by model year

Read on Ford’s own site between October 24, 2026 and October 26, 2026. Years not listed haven’t been checked yet, or their manual prints no value; check your own manual.

How to tighten them

  1. Clean any dirt or rust off the studs, the nuts and the wheel’s mounting face. Don’t oil them unless the manual says to.
  2. Thread every nut on by hand until it seats against the wheel.
  3. Lower the vehicle so the tire takes its weight, and set a torque wrench to 100 lb-ft (135 N·m).
  4. Tighten the nuts in a star pattern, going around two or three times, until the wrench clicks on every nut.
  5. Check the torque again after a short drive if your manual says to.

What the Ford manual adds

  • Retighten the lug nuts to the specified torque within 100 miles (160 km) after any wheel disturbance (rotation, flat tire, wheel removal, etc.).
  • Torque specifications are for nut and bolt threads free of dirt and rust.
  • Use only Ford recommended replacement fasteners.
  • Retighten the lug nuts to the specified torque at 50–100 miles (80–160 km) after any wheel disturbance (rotation, flat tire, wheel removal, etc.).

More detail, including how many passes to make: how to torque lug nuts. Setting and using the wrench: how to use a click torque wrench. Nuts or bolts, car by car: lug nuts vs wheel bolts.

Other Ford models

Questions

What is the lug nut torque on a Ford Explorer Sport Trac?

100 lb-ft (135 N·m), as printed in Ford’s owner’s manuals (2004–2005, 2007–2010).

Can I use an impact wrench?

Not to finish. An impact wrench can’t set a torque and easily overshoots it, which stretches studs. Run the nuts down by hand or lightly, then finish with a torque wrench in a star pattern.

Should I oil the studs?

Not unless the manual says so. Torque values assume clean, dry threads; oil lets the same torque stretch the stud further. Some manuals, Kia’s and Mazda’s among them, say to keep oil and grease off wheel nuts and bolts altogether.