Nissan Kicks lug nut torque

The Nissan Kicks takes 83 lb-ft (113 N·m) on its wheel nuts; the 2018–2027 manuals all say the same. Tighten them in a star pattern with a torque wrench.

Sources checked

Wheel nut torque

83lb-ft113N·m

04080120050100150ft-lbN·m
As printed
“Wheel nut tightening torque: 83 ft-lb (113 N·m)”
Source
2027 Kicks Owner's Manual (Nissan): PDF page 425

Nissan Kicks lug nut torque by model year

Model yearTorqueManual page
202783 lb-ft (113 N·m)PDF page 425
202683 lb-ft (113 N·m)PDF page 496
202583 lb-ft (113 N·m)PDF page 560
202483 lb-ft (113 N·m)PDF page 433
202383 lb-ft (113 N·m)PDF page 431
202283 lb-ft (113 N·m)PDF page 437
202183 lb-ft (113 N·m)PDF page 435
202083 lb-ft (113 N·m)PDF page 395
201983 lb-ft (113 N·m)PDF page 337
201883 lb-ft (113 N·m)PDF page 336

Read on Nissan’s own site between October 14, 2026 and October 19, 2026. Years not listed haven’t been checked yet, or their manual prints no value; check your own manual.

How to tighten them

  1. Clean any dirt or rust off the studs, the nuts and the wheel’s mounting face. Don’t oil them unless the manual says to.
  2. Thread every nut on by hand until it seats against the wheel.
  3. Lower the vehicle so the tire takes its weight, and set a torque wrench to 83 lb-ft (113 N·m).
  4. Tighten the nuts in a star pattern, going around two or three times, until the wrench clicks on every nut.
  5. Check the torque again after a short drive if your manual says to.

More detail, including how many passes to make: how to torque lug nuts. Setting and using the wrench: how to use a click torque wrench. Nuts or bolts, car by car: lug nuts vs wheel bolts.

Other Nissan models

Questions

What is the lug nut torque on a Nissan Kicks?

83 lb-ft (113 N·m), as printed in Nissan’s owner’s manuals (2018–2027).

Can I use an impact wrench?

Not to finish. An impact wrench can’t set a torque and easily overshoots it, which stretches studs. Run the nuts down by hand or lightly, then finish with a torque wrench in a star pattern.

Should I oil the studs?

Not unless the manual says so. Torque values assume clean, dry threads; oil lets the same torque stretch the stud further. Some manuals, Kia’s and Mazda’s among them, say to keep oil and grease off wheel nuts and bolts altogether.