Nissan Altima lug nut torque

The Nissan Altima takes 83 lb-ft (113 N·m) on its wheel nuts; the 2013–2027 manuals all say the same. Tighten them in a star pattern with a torque wrench.

Sources checked

Wheel nut torque

83lb-ft113N·m

04080120050100150ft-lbN·m
As printed
“Wheel nut tightening torque: 83 ft-lb (113 N·m)”
Source
2027 Altima Owner's Manual (Nissan): PDF page 337

Nissan Altima lug nut torque by model year

Model yearVersionTorqueManual page
2027All83 lb-ft (113 N·m)PDF page 337
2026All83 lb-ft (113 N·m)PDF page 398
2025All83 lb-ft (113 N·m)PDF page 436
2024All83 lb-ft (113 N·m)PDF page 476
2023All83 lb-ft (113 N·m)PDF page 480
2022All83 lb-ft (113 N·m)PDF page 494
2021All83 lb-ft (113 N·m)PDF page 462
2020All83 lb-ft (113 N·m)PDF page 437
2019All83 lb-ft (113 N·m)PDF page 450
2018All83 lb-ft (113 N·m)PDF page 359
2017All83 lb-ft (113 N·m)PDF page 402
2016All83 lb-ft (113 N·m)PDF page 387
2015All83 lb-ft (113 N·m)PDF page 350
2014All83 lb-ft (113 N·m)PDF page 396
2013All83 lb-ft (113 N·m)PDF page 381
2013Coupe83 lb-ft (113 N·m)PDF page 318

Read on Nissan’s own site between October 14, 2026 and October 22, 2026. Years not listed haven’t been checked yet, or their manual prints no value; check your own manual.

How to tighten them

  1. Clean any dirt or rust off the studs, the nuts and the wheel’s mounting face. Don’t oil them unless the manual says to.
  2. Thread every nut on by hand until it seats against the wheel.
  3. Lower the vehicle so the tire takes its weight, and set a torque wrench to 83 lb-ft (113 N·m).
  4. Tighten the nuts in a star pattern, going around two or three times, until the wrench clicks on every nut.
  5. Check the torque again after a short drive if your manual says to.

More detail, including how many passes to make: how to torque lug nuts. Setting and using the wrench: how to use a click torque wrench. Nuts or bolts, car by car: lug nuts vs wheel bolts.

Other Nissan models

Questions

What is the lug nut torque on a Nissan Altima?

83 lb-ft (113 N·m), as printed in Nissan’s owner’s manuals (2013–2027).

Can I use an impact wrench?

Not to finish. An impact wrench can’t set a torque and easily overshoots it, which stretches studs. Run the nuts down by hand or lightly, then finish with a torque wrench in a star pattern.

Should I oil the studs?

Not unless the manual says so. Torque values assume clean, dry threads; oil lets the same torque stretch the stud further. Some manuals, Kia’s and Mazda’s among them, say to keep oil and grease off wheel nuts and bolts altogether.