Polestar 3 lug nut torque
The 2025 Polestar 3 takes 103 lb-ft (140 N·m) on its wheel nuts, according to its owner’s manual. Tighten them in a star pattern with a torque wrench.
Sources checked
Wheel nut torque
103lb-ft140N·m
- As printed
- “Tighten to 140 Nm (103 lb-ft).”
Polestar 3 lug nut torque by model year
| Model year | Torque | Manual page |
|---|---|---|
| 2025 | 103 lb-ft (140 N·m) | Changing wheels |
Read on Polestar’s own site on October 23, 2026. Years not listed haven’t been checked yet, or their manual prints no value; check your own manual.
How to tighten them
- Clean any dirt or rust off the studs, the nuts and the wheel’s mounting face. Don’t oil them unless the manual says to.
- Thread every nut on by hand until it seats against the wheel.
- Lower the vehicle so the tire takes its weight, and set a torque wrench to 103 lb-ft (140 N·m).
- Tighten the nuts in a star pattern, going around two or three times, until the wrench clicks on every nut.
- Check the torque again after a short drive if your manual says to.
More detail, including how many passes to make: how to torque lug nuts. Setting and using the wrench: how to use a click torque wrench. Nuts or bolts, car by car: lug nuts vs wheel bolts.
Other Polestar models
Questions
What is the lug nut torque on a Polestar 3?
103 lb-ft (140 N·m), as printed in Polestar’s owner’s manual (2025).
Can I use an impact wrench?
Not to finish. An impact wrench can’t set a torque and easily overshoots it, which stretches studs. Run the nuts down by hand or lightly, then finish with a torque wrench in a star pattern.
Should I oil the studs?
Not unless the manual says so. Torque values assume clean, dry threads; oil lets the same torque stretch the stud further. Some manuals, Kia’s and Mazda’s among them, say to keep oil and grease off wheel nuts and bolts altogether.