GMC Yukon lug nut torque
The GMC Yukon takes 140 lb-ft (190 N·m) on its wheel nuts; the 2007–2027 manuals all say the same. Tighten them in a star pattern with a torque wrench.
Sources checked
Wheel nut torque
140lb-ft190N·m
- As printed
- “Wheel Nut Torque 190 N·m 140 lb ft”
GMC Yukon lug nut torque by model year
Read on GMC’s own site between October 14, 2026 and October 19, 2026. Years not listed haven’t been checked yet, or their manual prints no value; check your own manual.
How to tighten them
- Clean any dirt or rust off the studs, the nuts and the wheel’s mounting face. Don’t oil them unless the manual says to.
- Thread every nut on by hand until it seats against the wheel.
- Lower the vehicle so the tire takes its weight, and set a torque wrench to 140 lb-ft (190 N·m).
- Tighten the nuts in a star pattern, going around two or three times, until the wrench clicks on every nut.
- Check the torque again after a short drive if your manual says to.
More detail, including how many passes to make: how to torque lug nuts. Setting and using the wrench: how to use a click torque wrench. Nuts or bolts, car by car: lug nuts vs wheel bolts.
Other GMC models
- GMC Acadia140 lb-ft (190 N·m), 2007–2027
- GMC Canyon100 or 140 lb-ft, by model year, 2007–2012, 2015–2027
- GMC Envoy100 lb-ft (140 N·m), 2007–2009
- GMC Hummer EV140 lb-ft (190 N·m), 2022–2026
- GMC Savana140 lb-ft (190 N·m), 2007–2027
- GMC Sierra 1500140 lb-ft (190 N·m), 2007–2027
- GMC Sierra EV140 lb-ft (190 N·m), 2024–2027
- GMC Sierra HD140 lb-ft (190 N·m), 2007–2018, 2020–2026
- GMC Terrain100, 125 or 140 lb-ft, by model year, 2010–2027
- GMC Yukon XL140 lb-ft (190 N·m), 2007–2027
Questions
What is the lug nut torque on a GMC Yukon?
140 lb-ft (190 N·m), as printed in GMC’s owner’s manuals (2007–2027).
Can I use an impact wrench?
Not to finish. An impact wrench can’t set a torque and easily overshoots it, which stretches studs. Run the nuts down by hand or lightly, then finish with a torque wrench in a star pattern.
Should I oil the studs?
Not unless the manual says so. Torque values assume clean, dry threads; oil lets the same torque stretch the stud further. Some manuals, Kia’s and Mazda’s among them, say to keep oil and grease off wheel nuts and bolts altogether.